It may have just been my experience, but beware of the pre-installed screws that you eventually have to unfasten to install the fan blades. The screws were so tight I had to spend extra money on an impact driver just to get them out and even then two would not budge. Some WD-40 and and a needle-nosed vice grip later and I was finally able to get them out. I would suggest unfastening the screws before you put the fan into the ceiling, this will give you better leverage at least. I was disappointed at the end because I ended up paying more for the tools to get these screws free than what I actually spent on the fan itself! Bah.
Terrible time putting together
It may have just been my experience, but beware of the pre-installed screws that you eventually have to unfasten to install the fan blades. The screws were so tight I had to spend extra money on an impact driver just to get them out and even then two would not budge. Some WD-40 and and a needle-nosed vice grip later and I was finally able to get them out. I would suggest unfastening the screws before you put the fan into the ceiling, this will give you better leverage at least. I was disappointed at the end because I ended up paying more for the tools to get these screws free than what I actually spent on the fan itself! Bah.